Datalink Systems i50 Dokumentacja Pobierz pdf (Strona 35)

i50 Manual (5.10)

Page 35

www.datalinksystemsinc.com

Note: to connect a PC to the COM2 or COM3 ports you will need a null-modem adapter with

RX/TX pins crossed over.

Shortcut buttons are provided on the right side of the window, allowing quick access to modules

using the default port and COM speed for each module.

The Test Wi-Fi command sends a request to the current port for the Wi-Fi version number.

Use the Send ATI command to quickly send an ATI request to the current port.

The Enfora Pass command provides a quick way to program a password into an Enfora modem. See

section 8.11 for an important note about Enfora passwords.

7.4.1 Direct Mode

The Direct Mode checkbox causes the i50 to map the current programming port directly to the

selected port. Once connected, the i50B Programmer utility will close the PC COM port, allowing

another program to connect to the port to access the i50. Since the i50 is no longer processing the

serial data itself, it will not respond to the programmer until rebooted.

Direct mode is useful if you need to communicate with an i50 port using a third-party program.

Specific examples of this are when upgrading the firmware of the internal modems, or using the U-

Blox GPS programming software to fine-tune the GPS receiver.

7.4.2 Wi-Fi Firmware Update

A special command button labelled Wi-Fi Prog is provided for updating the firmware of the internal

Wi-Fi module. This option applies power to the Wi-Fi module when programming signals are

detected. The i50B Wi-Fi Update file on the Datalink downloads web page contains firmware and

detailed instructions.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 64 65

Brak uwag

Datalink Systems i50 Dokumentacja Strona 35